The base weight of the item, without any packaging.

18 available for pre-ordering
Weight WeightThe base weight of the item, without any packaging. |
1.3 kg |
|---|---|
| Dimensions | 14 × 14 × 14 cm |
| Barbell Type | Olympic (50mm) |
| Mounting Type | Rack Mounted |
| Rack Series | 500, 600, 700, 800 |
| Construction | Nylon bracket with steel bolts |
Weight WeightThe base weight of the item, without any packaging. |
2kg |
Footprint Footprint
This is the area occupied by the item itself. You might need to allocate additional space for the use.
|
7 x 11.5 x 10.5cm |
| Colour | Black |
Inclusions InclusionsThese are the specific items that you will receive when you purchase the product. Some products are shown with items that are not included for demonstration purposes. |
Sold Individually |
| Warranty | 5-Year Manufacturer's Warranty |
| Safe Working Load | 40kg |
A big plus of this bar holder is the simplicity of the design. Using one bolt it connects to your rack at whichever height you like, and it is easily adjusted using the quick release feature.
Because of this adjustability, you are not limited to just 7 ft barbells. You can store specialty Olympic barbells, such as the EZ Curl and Super Curl bars.
The main benefit of this design is that the bar goes in from the side, so you only need to lift the barbell up by a couple of centimeters to unrack it and you do not need extra ceiling height. That makes it well suited to gyms with low ceilings.
It fits ATX 500, 600, 700 and 800 series rigs and racks, except the ATX Fold Back Half Rack 750 (ATX-FBR-750), and it is certified to EN 20957 I.II.IV Class S (studio).

A 20 mm steel axle bolt with a quick-fit split pin lets you fix it at the height you want.

Hang the bar in from the side with no extra ceiling height needed.

Break-proof plastic with edge protection keeps your bar and rack paint from getting scratched.


Fix the holder at the height you like, hang your bar in from the side and keep it within easy reach. A built-in lip helps stop the barbell from falling out.
Because the holder is a single bolt-on piece, you can move it up or down the upright whenever your setup changes.
The bar holder suits ATX rigs and racks in the 500, 600, 700 and 800 series. It cannot be used on the uprights of the ATX Fold Back Half Rack 750 (ATX-FBR-750).

Not included: the rack or rig, and the barbell shown in the pictures.
Please note the pictures may feature optional attachments or items which are not included with the unit, this is to show the possible configurations/use of the unit.
NOT RECOMMENDED for use with squat stands. If you are planning on using this attachment with your ATX Squat Stand, make sure that it is secure properly (Squat Stands Brace – ATX-SQS-BRA), to prevent the squat stands from tipping over.
You must be logged in to post a review.

Reviews
There are no reviews yet.